192.168.178.1

192.168.178.1 IP Address

If you want to access the admin page, you need to open browser and type 192.168.178.1 in the address bar.

Or just simple click one of those Buttons below.


This should be your local IP Address and Router Admin. It works if you are in the same network as the router.

Note: If the button above does not work, it means that the default gateway used is not the IP address, and you can only open the router login page if you are logged into the same network.


some people type it wrong, like 192.168.178. 1

Default Logins for 192.168.178.1

IP Address
Username
Password

192.168.178.1 Login Steps

If you want to access the panel admin, you should login to router’s address. In this case, you need to know the login steps of 192.168.178.1 with these following steps.

  1. Router’s Cable

    I know that you can use the wireless network. But for safety purpose, we recommend using wired network. Check if the router’s cable has been plugged in correctly. Connect the cable to the device you wish to work. Plus, make sure it has internet connection.

  2. Type IP Address Correctly

    Avoid mistyping as it will lead you to an error page. This thing happens all the time and people are freaking out. But if you’ve type the IP address correctly and it still didn’t work, you need to find the right IP address on the router’s box.

  3. Enter Username and Password

    You need to enter the username and password on the login page. The default value for both of them sometimes are ‘admin’ or ‘user’ or ‘root’. If those didn’t work, use the Default Logins for 192.168.178.1 on the list above.

Troubleshooting Methods

Reset the Router
It’s okay to reset the router and revert it to factory setting. You can do this if you have forgot your password and username. Press the reset button and hold it for 10 seconds. By the time it turns on, it’s already set to default settings.

Login Page won’t Load
It usually happens because you don’t have internet connection. A slow internet connection might as well interrupt the page to load. Also, make sure you have selected the right router IP address as the default.

IP Conflict
IP Conflict occurs as there’s more than just one router at the vicinity. You should change the router’s setting to static mode. It will prevent IP conflict and give you extra protection as hackers couldn’t access it.

Leave a Comment