APC Router Login – IP Address, Username, Password

Default IP Address for APC Router

192.168.1.1

Default Logins for APC Router

IP Address
Username
Password

APC Router Login Steps

WMR1000G is the only one model using APC router. It uses 192.168.1.1 as the default IP Address. Follow this step to login to your router’s CPanel where you can change the configuration setup.

  1. Wired Network

    We prefer wired network as it is reliable and safe. Also, it doesn’t need WiFi password so you are good to go without it. To do this, you have to connect the Ethernet cable to your device and the LAN Port.

  2. Use Default IP Address

    Use the default IP Address given and open it on a new tab. If not, you can click one of the buttons on the ‘Default IP address’ section of this page.

  3. Enter User and Password

    From what we know, the username is ‘Admin’ and the password is ‘APC’. Try this credential and if it is not working, use default user and password given by your router brands.

APC Routers FAQs & Troubleshooting

Forgot Login Page

If this one happens to you, you can proceed to reset the router. When it is on again, use default credentials to access the admin panel of your router.

How do I Reset APC Router?

You can reset the router by pressing the Reset button. Use small stick to press and hold the button for a few seconds. By the time it turns on, the router has reverted to factory setting.

I Can’t Open Login Page

If it happen, then you might use the wrong IP Address. Other than that, there’s another network around you that causes IP Conflict. Locate the correct address to access the login page.

Leave a Comment